enow.com Web Search

  1. Ads

    related to: adding coolant directly to radiator

Search results

  1. Results from the WOW.Com Content Network
  2. Radiator (engine cooling) - Wikipedia

    en.wikipedia.org/wiki/Radiator_(engine_cooling)

    a radiator, consisting of many small tubes equipped with a honeycomb of fins to dissipate heat rapidly, that receives and cools hot liquid from the engine; a water pump, usually of the centrifugal type, to circulate the coolant through the system; a thermostat to control temperature by varying the amount of coolant going to the radiator;

  3. Internal combustion engine cooling - Wikipedia

    en.wikipedia.org/wiki/Internal_combustion_engine...

    Only the fixed parts of the engine, such as the block and head, are cooled directly by the main coolant system. Moving parts such as the pistons, and to a lesser extent the crankshaft and connecting rods, must rely on the lubrication oil as a coolant, or to a very limited amount of conduction into the block and thence the main coolant. High ...

  4. Oil cooling - Wikipedia

    en.wikipedia.org/wiki/Oil_cooling

    Oil cooling is the use of engine oil as a coolant, typically to remove surplus heat from an internal combustion engine. The hot engine transfers heat to the oil which then usually passes through a heat-exchanger, typically a type of radiator known as an oil cooler. The cooled oil flows back into the hot object to cool it continuously.

  5. Should I replace the drive belt and radiator hoses when ... - AOL

    www.aol.com/replace-drive-belt-radiator-hoses...

    I am planning a 5,000-mile trip. Should I replace the original drive belt and radiator hoses when I have the coolant changed?

  6. Heater core - Wikipedia

    en.wikipedia.org/wiki/Heater_core

    A heater core is a radiator-like device used in heating the cabin of a vehicle. Hot coolant from the vehicle's engine is passed through a winding tube of the core, a heat exchanger between coolant and cabin air. Fins attached to the core tubes serve to increase surface area for heat transfer to air that is forced past them by a fan, thereby ...

  7. Water injection (engine) - Wikipedia

    en.wikipedia.org/wiki/Water_injection_(engine)

    Adding water increases the mass being accelerated out of the engine, increasing thrust and it also serves to cool the turbines. Since temperature is normally the limiting factor in turbine engine performance at low altitudes, the cooling effect lets the engine run at higher RPM with more fuel injected and more thrust created without overheating.

  1. Ads

    related to: adding coolant directly to radiator