Search results
Results from the WOW.Com Content Network
A SCSI connector (/ ˈ s k ʌ z i / SKUZ-ee) is used to connect computer parts that communicate with each other via the SCSI standard. Generally, two connectors, designated male and female, plug together to form a connection which allows two components, such as a computer and a disk drive, to communicate with each other.
Internal parallel SCSI cables are usually ribbons, with two or more 50–, 68–, or 80–pin connectors attached. External cables are typically shielded (but may not be), with 50– or 68–pin connectors at each end, depending upon the specific SCSI bus width supported.
Pages in category "Computer connectors" The following 52 pages are in this category, out of 52 total. This list may not reflect recent changes. ...
This connector has been standardized for RS-232 as TIA-574. Some miniaturized electronics, particularly graphing calculators [5] and hand-held amateur and two-way radio equipment, [6] have serial ports using a phone connector, usually the smaller 2.5 or 3.5 mm connectors and the most basic 3-wire interface—transmit, receive and ground.
The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data. [a] An additional cable was used for power, initially frequently AC but later usually connected directly to a DC power supply unit. The controller provided significant functions ...
Examples of computer connector sockets on various laptops Ports on the back of the Apple Mac Mini (2005) A computer port is a hardware piece on a computer where an electrical connector can be plugged to link the device to external devices, such as another computer, a peripheral device or network equipment. [1] This is a non-standard term.
A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector.
A PCI-104 single-board computer. PC/104 (or PC104) is a family of embedded computer standards which define both form factors and computer buses by the PC/104 Consortium.Its name derives from the 104 pins on the interboard connector in the original PC/104 specification [1] [2] and has been retained in subsequent revisions, despite changes to connectors.