enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Wrench size - Wikipedia

    en.wikipedia.org/wiki/Wrench_size

    spanner (wrench) size and thread diameter of a hex nut. Width across flats is the distance between two parallel surfaces on the head of a screw or bolt, or a nut, mostly for torque transmission by positive locking. The term width across flats (AF) is used for the following forms: 2-socket = round material with two surfaces

  3. IEC metric screw sized connectors - Wikipedia

    en.wikipedia.org/wiki/IEC_metric_screw_sized...

    IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.

  4. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).

  5. Twist-on wire connector - Wikipedia

    en.wikipedia.org/wiki/Twist-on_wire_connector

    Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...

  6. Spacers and standoffs - Wikipedia

    en.wikipedia.org/wiki/Spacers_and_standoffs

    They are usually round or hex (for wrench tightening), often made of stainless steel, aluminum, brass, or nylon, and come in male-female or female-female forms. In electronics they are frequently used to raise a printed-circuit board above a surface. Insulating standoffs keep two parts from touching each other, thereby preventing electrical shorts.

  7. IEC 60309 - Wikipedia

    en.wikipedia.org/wiki/IEC_60309

    The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

  8. Wrench - Wikipedia

    en.wikipedia.org/wiki/Wrench

    A wrench used to turn screw or bolt heads designed with a hexagonal socket (recess) to receive the wrench. The wrenches come in two common forms: L-shaped and T-handles. The L-shaped wrenches are formed from hexagonal wire stock, while the T-handles are the same hex wire stock with a metal or plastic handle attached to the end.

  9. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    A plow bolt is bolt similar to a carriage bolt, except the head is flat or concave, and the underside of the head is a cone designed to fit in a countersunk recess. Plow bolts provide a smooth surface for attaching a plow moldboard to its beam, where a raised head would suffer from soil abrasion. There are many variations, with some not using a ...