Search results
Results from the WOW.Com Content Network
It is defined as the pressure exerted by a column of water of 1 inch in height at defined conditions. At a temperature of 4 °C (39.2 °F) pure water has its highest density (1000 kg/m 3). At that temperature and assuming the standard acceleration of gravity, 1 inAq is approximately 249.082 pascals (0.0361263 psi). [2]
British thermal unit (60 °F) BTU 60 °F: ≈ 1.054 68 × 10 3 J: British thermal unit (63 °F) BTU 63 °F: ≈ 1.0546 × 10 3 J: calorie (International Table) cal IT: ≡ 4.1868 J = 4.1868 J: calorie (mean) cal mean: 1 ⁄ 100 of the energy required to warm one gram of air-free water from 0 °C to 100 °C at a pressure of 1 atm ≈ 4.190 02 J ...
The miner’s inch measures the amount of water that would flow through a slot of a given area at a given pressure (for example, at a head of 6 inches of water, or 1.5 kPa.) In miner's inch the word inch refers to the area of the slot in square inches, while the pressure in inches of water refers to the height of water above the slot. A ...
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
SG is the specific gravity of the fluid (for water = 1), ΔP is the pressure drop across the valve (expressed in psi). In more practical terms, the flow coefficient C v is the volume (in US gallons) of water at 60 °F (16 °C) that will flow per minute through a valve with a pressure drop of 1 psi (6.9 kPa) across the valve.
A centimetre of water [1] is a unit of pressure. It may be defined as the pressure exerted by a column of water of 1 cm in height at 4 °C (temperature of maximum density) at the standard acceleration of gravity, so that 1 cmH 2 O (4°C) = 999.9720 kg/m 3 × 9.80665 m/s 2 × 1 cm = 98.063754138 Pa ≈ 98.0638 Pa, but conventionally a nominal maximum water density of 1000 kg/m 3 is used, giving ...
In 1824, these units were replaced with a single system based on the imperial gallon. [a] Originally defined as the volume of 10 pounds (4.54 kg) of distilled water (under certain conditions), [b] then redefined by the Weights and Measures Act 1985 to be exactly 4.546 09 L (277.4 cu in), the imperial gallon is close in size to the old ale gallon.
In SI units, 1 psi is approximately 6,895 pascals. The pound per square inch absolute (psia) is used to make it clear that the pressure is relative to a vacuum rather than the ambient atmospheric pressure. Since atmospheric pressure at sea level is around 14.7 psi (101 kilopascals), this will be added to any pressure reading made in air at sea ...