Search results
Results from the WOW.Com Content Network
Such plants can operate at 23–27 kWh/m 3 (appr. 90 MJ/m 3) of distilled water. [5] Because the colder salt water entering the process counterflows with the saline waste water/distilled water, relatively little heat energy leaves in the outflow—most of the heat is picked up by the colder saline water flowing toward the heater and the energy ...
The salt water collected at the bottom of each stage can be sprayed on the tubes in the next stage, since this water has a suitable temperature and pressure near or slightly above the operating temperature and pressure in the next stage. Some of this water will flash into steam as it is released into the next stage at lower pressure than the ...
Desalination is a process that removes mineral components from saline water. More generally, desalination is the removal of salts and minerals from a substance. [1] One example is soil desalination. This is important for agriculture. It is possible to desalinate saltwater, especially sea water, to
The VVC process is the more efficient distillation process available in the market today in terms of energy consumption and water recovery ratio. [1] As the system is electrically driven, it is considered a "clean" process, it is highly reliable and simple to operate and maintain.
Also, the effluent of existing sea water desalination plants can be treated further in a low temperature distillation to maximise the dewatering capacity of a desalination system. Low temperature distillation can accommodate variations in the plant load, running efficiently from 50 – 100% of plant design capacity depending on the available ...
Sea-water RO (SWRO) desalination requires around 3 kWh/m 3, much higher than those required for other forms of water supply, including RO treatment of wastewater, at 0.1 to 1 kWh/m 3. Up to 50% of the seawater input can be recovered as fresh water, though lower recovery rates may reduce membrane fouling and energy consumption.
Multiple-effect humidification (MEH) is a method used for thermal desalination of sea water. It uses multiple evaporation–condensation cycles at separate temperature levels to minimize the total energy consumption of solar humidification processes. [1]
Seawater, or sea water, is water from a sea or ocean. On average, seawater in the world's oceans has a salinity of about 3.5% (35 g/L, 35 ppt, 600 mM). This means that every kilogram (roughly one liter by volume) of seawater has approximately 35 grams (1.2 oz) of dissolved salts (predominantly sodium ( Na +