Search results
Results from the WOW.Com Content Network
The bush pump, also known as the Zimbabwe bush pump, is a positive displacement pump based on lever action [1] used to extract water from a bore hole well. It is the standard hand pump in Zimbabwe, and is used in Zimbabwe and Namibia. There are approximately 40 000 pumps (2009) [2] in Zimbabwe, and annually about 3000 pumps are installed. [3]
A diagram of a pumpjack. A pumpjack is the overground drive for a reciprocating piston pump in an oil well. [1] It is used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface. The arrangement is often used for onshore wells. Pumpjacks are common in oil-rich areas.
A broken India Mark II pump in rural Uganda A busy Mark II pump in Uganda. Children often bear the responsibility for collecting water. Durability needs to be incorporated into pump design to the handle the heavy use (and abuse). The India Mark II is a human-powered pump designed to lift water from a depth of 50–80 m. [1]
These pumps, often submersible and powered by electricity, can access water reserves located much deeper than shallow wells, ensuring a consistent supply even during periods of drought. They include different kinds of pumps, most of them submersible pumps: Hand pump, manually operated; Injector, a jet-driven pump; Mechanical or rotary lobe pump ...
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom.
The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to be lifted to a point higher than where the water originally started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower and a need for pumping water to a destination ...
A treadle pump is a human-powered suction pump that sits on top of a well and is used for irrigation. [1] It is designed to lift water from a depth of seven metres or less. The pumping is activated by stepping up and down on a treadle, which are levers, which drive pistons, creating cylinder suction that draws groundwater to the surface.
Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...