Search results
Results from the WOW.Com Content Network
As a result, O'Brien and Shelton's work was rejected. In 1958, the National Bureau of Standards invented a new sizing system, based on the hourglass figure and using only the bust size to create an arbitrary standard of sizes ranging from 8 to 38, with an indication for height (short, regular, and tall) and lower-body girth (plus or minus). The ...
There is no mandatory clothing size or labeling standard in the US, though a series of voluntary standards have been in place since the 1930s. The US government, however, did attempt to establish a system for women's clothing in 1958 when the National Bureau of Standards published Body Measurements for the Sizing of Women's Patterns and Apparel .
The joint European standard for size labelling of clothes, formally known as the EN 13402 Size designation of clothes, is a European standard for labelling clothes sizes. The standard is based on body dimensions measured in centimetres, and as such, and its aim is to make it easier for people to find clothes in sizes that fit them. The standard ...
The size denotes the width of the faceplate for the installed equipment. The rack unit is a measure of vertical spacing and is common to both the 19 and 23-inch racks. Hole spacing is either on 1-inch (25 mm) centers (Western Electric standard), or the same as for 19-inch (482.6 mm) racks (0.625 in or 15.9 mm spacing).
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".
The current British Standard for metallic materials including wire is BS 6722:1986, which is a solely metric standard, superseding 3737:1964, which used the SWG system. The IEC 60228, used in most parts of the world, defines standard wire sizes based on their cross-sectional areas as expressed in mm 2. [3]
The #6-32 UNC screw has a thread pitch of 1/32 in (0.031250 inches (0.7938 mm)).. The #6-32 UNC is a UTS screw specifying a major thread diameter of #6 which is defined as 0.1380 inches (3.51 mm); and 32 tpi (threads per inch) which equates to a thread pitch of 0.031250 inches (0.7938 mm).