enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch force required to punch a piece of sheet metal can be estimated from the following equation: [4] F = 0.7 t L ( U T S ) {\displaystyle F=0.7tL(UTS)} Where t is the sheet metal thickness, L is the total length sheared (perimeter of the shape), and UTS is the ultimate tensile strength of the material.

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

4. Stitching awl - Wikipedia

   en.wikipedia.org/wiki/Stitching_awl

   A small copper awl from a Tel Tsaf grave in Israel is currently the oldest metal object discovered in the Middle East. [1] Native American, Plains, Northern. Awl Case, Brooklyn Museum. Awls were used by the Eastern and Middle Dakota and by the peoples of the Red River region, including the Red River Métis, Anishinabe, Plains Cree, and Salteaux.

5. Blanking and piercing - Wikipedia

   en.wikipedia.org/wiki/Blanking_and_piercing

   This allows for complex shapes to be formed in sheet metal up to 6 mm (0.25 in) thick using simple tools. [4] that is essentially a small punch and die that reciprocates quickly; around 300–900 times per minute. Punches are available in various shape and sizes; oblong and rectangular punches are common because they minimize waste and allow ...

6. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

7. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   The Adell and Starrett mechanism uses a sliding block crosswise through the hammer rather than an intermediate pin. The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered. The sliding block has a hole through it that, when reset, is misaligned with the hole through the hammer.