enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...

3. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   12V only power connector (labelled P1, though it is not compatible with the ATX 20 or 24 pin connector): This is a 10 or 16-pin Molex connector supplying the motherboard with three or six 12 V lines with common returns, a 'supply OK' signal, a 'PSU ON' signal and a 12 or 11 V auxiliary supply. One pin is left unused.

4. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   The most notable difference from modern 20/24-pin ATX power connectors is that the AT power supply connector did not have a signal to turn on the power supply, and also did not supply separate, "always-on" +5V standby power. The power supply was instead turned on and off via a mechanical switch that disconnected mains power. Modern, ATX ...

5. Power good signal - Wikipedia

   en.wikipedia.org/wiki/Power_good_signal

   The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).

6. File:ATX PS signals.svg - Wikipedia

   en.wikipedia.org/wiki/File:ATX_PS_signals.svg

   English: Pinouts of ATX power supply connectors, displayed according to Intel's Power Supply Design Guide for Desktop Platform Form Factors v1.2 (2008) and v1.31 (2013) COM = COMMON VSB = Volts Stand-By

7. PS-ON Signal - Wikipedia

   en.wikipedia.org/wiki/PS-ON_Signal

   PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...

8. Berg connector - Wikipedia

   en.wikipedia.org/wiki/Berg_connector

   The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [1]

9. IC power-supply pin - Wikipedia

   en.wikipedia.org/wiki/IC_power-supply_pin

   IC power-supply pins denote a voltage and current supply terminals in electric, electronics engineering, and in integrated circuit design. [a] Integrated circuits (ICs) have at least two pins that connect to the power rails of the circuit in which they are installed. These are known as the power-supply pins. However, the labeling of the pins ...