Search results
Results from the WOW.Com Content Network
1 Specification for coarse and fine aggregate. IS 383 - 1970 2 Specification for compressive strength, flexural strength IS 516 - 1959 3 Code of Practices for plain and reinforced concrete etc. IS 456 – 2000 4 Methods of sampling and analysis of concrete IS 1199 – 1959 5 Recommended Guide Lines for Concrete Mix Design IS 10262 – 1982
Figure 2 - Failure probability and target service life in performance-based service life models for reinforced concrete structures. Performance-based approaches provide for a real design of durability, based on models describing the evolution in time of degradation processes, and the definition of times at which defined limit states will be ...
(2) The thermal expansion coefficients of concrete and steel are so close (1.0 × 10 −5 to 1.5 × 10 −5 for concrete and 1.2 × 10 −5 for steel) that the thermal stress-induced damage to the bond between the two components can be prevented. (3) Concrete can protect the embedded steel from corrosion and high-temperature induced softening.
EN 1992-1-2 deals with the design of concrete structures for the accidental situation of fire exposure and is intended to be used in conjunction with EN 1992-1-1 and EN 1991-1-2. This part 1-2 only identifies differences from, or supplements to, normal temperature design. Part 1-2 of EN 1992 deals only with passive methods of fire protection.
Unlike an I-beam, a T-beam lacks a bottom flange, which carries savings in terms of materials, but at the loss of resistance to tensile forces. [5] T- beam designs come in many sizes, lengths and widths to suit where they are to be used (eg highway bridge, underground parking garage) and how they have to resist the tension, compression and shear stresses associated with beam bending in their ...
The density of concrete varies, but is around 2,400 kilograms per cubic metre (150 lb/cu ft). [1] Reinforced concrete is the most common form of concrete. The reinforcement is often steel rebar (mesh, spiral, bars and other forms). Structural fibers of various materials are available.
Fresh cement water has a pH of about 13.5 while evolved cement water pH ~ 12.5 is controlled by the dissolution of calcium hydroxide (portlandite). Carbon dioxide present in the air slowly diffuses through the concrete cover over the rebar and progressively reacts with the alkaline hydroxides ( KOH , NaOH ) and with calcium hydroxide leading to ...
The strength enhancing effects of arching action in reinforced concrete floors were first recognised near the beginning of last century. [1] However, it was not until the full scale destructive load tests by Ockleston [2] [3] on the Old Dental Hospital in Johannesburg that the extent of strength enhancement caused by arching action was really ...