Search results
Results from the WOW.Com Content Network
Also, importantly, address offsets are 32-bit (instead of 16-bit), and the segment base in each segment descriptor is also 32-bit (instead of 24-bit). The general operation of the segmentation unit is otherwise unchanged. The paging unit may be enabled or disabled; if disabled, operation is the same as on the 80286.
The x86 and x86-64 segment descriptor has the following form: [3] Where the fields stand for: Base Address Starting memory address of the segment. Its length is 32 bits and it is created from the lower part bits 16 to 31, and the upper part bits 0 to 7, followed by bits 24 to 31.
The primary defining characteristic of IA-32 is the availability of 32-bit general-purpose processor registers (for example, EAX and EBX), 32-bit integer arithmetic and logical operations, 32-bit offsets within a segment in protected mode, and the translation of segmented addresses to 32-bit linear addresses. The designers took the opportunity ...
Will change OperandSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. 67h: AddressSize override. Will change AddressSize from 16-bit to 32-bit if CS.D=0, or from 32-bit to 16-bit if CS.D=1. The 80386 also introduced the two new segment registers FS and GS as well as the x86 control, debug and test registers.
Four registers are used to refer to four segments on the 16-bit x86 segmented memory architecture. DS (data segment), CS (code segment), SS (stack segment), and ES (extra segment). Another 16-bit register can act as an offset into a given segment, and so a logical address on this platform is written segment:offset, typically in hexadecimal ...
In a system using segmentation, computer memory addresses consist of a segment id and an offset within the segment. [3] A hardware memory management unit (MMU) is responsible for translating the segment and offset into a physical address, and for performing checks to make sure the translation can be done and that the reference to that segment and offset is permitted.
The GDT is a table of 8-byte entries. Each entry may refer to a segment descriptor, Task State Segment (TSS), Local Descriptor Table (LDT), or call gate.Call gates were designed for transferring control between x86 privilege levels, although this mechanism is not used on most modern operating systems.
The field SS0 contains the stack segment selector for CPL=0, and the field ESP0/RSP0 contains the new ESP/RSP value for CPL=0. When an interrupt happens in protected (32-bit) mode, the x86 CPU will look in the TSS for SS0 and ESP0 and load their values into SS and ESP respectively. This allows for the kernel to use a different stack than the ...