Search results
Results from the WOW.Com Content Network
IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
A common coaxial power connector, male (left) and female (right), 5.5 × 2.5 mm. Connector gender is determined by the center contact. Note: connectors depicted do not connect with each other. Common DC power connectors. A coaxial power connector is an electrical power connector used for attaching extra-low voltage devices such as consumer ...
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
The Micro-A connector is 6.85 by 1.8 mm (0.270 by 0.071 in) with a maximum plug body size of 11.7 by 8.5 mm (0.46 by 0.33 in), while the Micro-B connector has the same height and width with a slightly smaller maximum plug body size of 10.6 by 8.5 mm (0.42 by 0.33 in). [9]
Local Connector [14] Latch — 1.25 mm IEC 61754-20 [8] High-density connections, SFP and SFP+ transceivers, XFP transceivers. [11] Duplex LC is comparable in size to RJ-45. [C] Luxcis 1.25 mm ARINC 801 PC (straight physical contact) or APC (angled physical contact) configurations LX-5 Latch, integral light- and dust-cap — IEC 61754-23
There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in). The 1.57 mm pin can carry 5 A of current, while the 2.36 mm can carry 8.5 A. Because the pins have a large contact surface area and fit tightly, these connectors are typically used for power.
MC4 connectors are successors of the MC3 Connectors, which were developed by Multi-Contact in 1996. MC3 is the abbreviation of Multi-Contact and its size 3mm PV connector with 3 mm contact pin. MC3 had certification ratings of (1000VIEC/600V UL) and 30A (10AWG PV Cable). The MC3 connectors were discontinued in 2016.