Search results
Results from the WOW.Com Content Network
IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.
Two pin sizes are standard in the jacks for this size plug body, 2.1 mm (0.083 in) and 2.5 mm (0.098 in), and the plugs should match. If the size is not known, it is difficult to distinguish by eye or measurement between the 2.1mm and 2.5mm ID plugs; some suppliers suggest simple methods. [1]
A common coaxial power connector, male (left) and female (right), 5.5 × 2.5 mm. Connector gender is determined by the center contact. Note: connectors depicted do not connect with each other. Common DC power connectors. A coaxial power connector is an electrical power connector used for attaching extra-low voltage devices such as consumer ...
Local Connector [14] Latch — 1.25 mm IEC 61754-20 [8] High-density connections, SFP and SFP+ transceivers, XFP transceivers. [11] Duplex LC is comparable in size to RJ-45. [C] Luxcis 1.25 mm ARINC 801 PC (straight physical contact) or APC (angled physical contact) configurations LX-5 Latch, integral light- and dust-cap — IEC 61754-23
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
Air cored Microwave connectors The name of a connector (e.g. 1.85) is determined by the diameter in mm of the air dielectric around the centre pin 3.5 and 2.92 mm (sometimes called K) connectors, which also have a 0.9mm centre pin and cross-mate with SMA and offer higher maximum frequency
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.