enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Concealed hinge jig - Wikipedia

   en.wikipedia.org/wiki/Concealed_hinge_jig

   Concealed hinge drilling jig with embedded Forstner bit. A concealed hinge drilling jig is a type of support jig, designed for drilling 3 cm holes to fit concealed hinges into modern wardrobe doors. As many of the complementary tools used in woodworking, it uses an electric hand-drill for its operation, making a Forstner bit to turn.

3. V-block - Wikipedia

   en.wikipedia.org/wiki/V-block

   They consist of a rectangular steel or cast iron block with a 120 degree channel rotated 45-degrees from the sides, forming a V-shaped channel in the top. A small groove is cut in the bottom of the "V". They often come with screw clamps to hold the work. There are also versions with internal magnets for magnetic work-holding.

4. Dovetail joint - Wikipedia

   en.wikipedia.org/wiki/Dovetail_joint

   A finished dovetail joint Dovetailed woodworking joints on a Romanian church Stone pillar at the Vazhappally Maha Siva Temple. A dovetail joint or simply dovetail is a joinery technique most commonly used in woodworking joinery (carpentry), including furniture, cabinets, [1] log buildings, and traditional timber framing.

5. Fixture (tool) - Wikipedia

   en.wikipedia.org/wiki/Fixture_(tool)

   A common type of fixture, used in materials tensile testing (Grip-Engineering). A fixture is a work-holding or support device used in the manufacturing industry. [1] [2] Fixtures are used to securely locate (position in a specific location or orientation) and support the work, ensuring that all parts produced using the fixture will maintain conformity and interchangeability.

6. SawStop - Wikipedia

   en.wikipedia.org/wiki/SawStop

   Bosch's new REAXX contractor's table saw appeared at the World of Concrete trade show in Las Vegas in February 2015. [17] The Bosch saw retracts the blade below the table, but unlike SawStop, it does not stop or damage the blade. Pro Tool Reviews published an article comparing the SawStop Jobsite Table Saw with the Bosch REAXX Jobsite Table Saw.

7. Clamper (electronics) - Wikipedia

   en.wikipedia.org/wiki/Clamper_(electronics)

   A negative clamp is the opposite of this—this clamp outputs a purely negative waveform from an input signal. A bias voltage between the diode and ground offsets the output voltage by that amount. For example, an input signal of peak value 5 V (V INpeak = 5 V) is applied to a positive clamp with a bias of 3 V (V BIAS = 3 V), the peak output ...