enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [18]: 61 [19] In addition, a well-designed system will often use two 45° elbows instead of one 90° elbow (even a sweep 90° elbow) to reduce flow disruption as much as possible. [18]: 61 Central vacuum system inlet fittings are intentionally designed with a tighter curvature radius than other bends in the system.

3. Plastic pipework - Wikipedia

   en.wikipedia.org/wiki/Plastic_pipework

   Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.

4. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

5. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

6. Table (furniture) - Wikipedia

   en.wikipedia.org/wiki/Table_(furniture)

   Most tables are composed of a flat surface and one or more supports (legs). A table with a single, central foot is a pedestal table. Long tables often have extra legs for support. Dinner table and chairs. Table tops can be in virtually any shape, although rectangular, square, round (e.g. the round table), and oval tops are the

7. ISO/IEC 7810 - Wikipedia

   en.wikipedia.org/wiki/ISO/IEC_7810

   The ID-1 format specifies a size of 85.60 by 53.98 millimetres (3 + 3 ⁄ 8 in × 2 + 1 ⁄ 8 in) and rounded corners with a radius of 2.88–3.48 mm (about 1 ⁄ 8 in). This format is also referred to as CR-80 and, for travel documents, TD1 .