Search results
Results from the WOW.Com Content Network
The rudder may also be called upon to counter-act the adverse yaw produced by the roll-control surfaces. If rudder is continuously applied in level flight the aircraft will yaw initially in the direction of the applied rudder – the primary effect of rudder. After a few seconds the aircraft will tend to bank in the direction of yaw.
Collection of control yokes at Boeing Future of Flight Museum: 747, 707, B-29, Trimotor.The former two yokes are W-shaped, while the latter two are circular. The cockpit of Concorde, which has an M-shaped yoke mounted on a control column The cockpit of an Embraer ERJ with an M-shaped yoke "W"/"U" style yoke in a Cessna 152 light aircraft, mounted on a horizontal tube protruding from the ...
In February 1976, work commenced to automate the methods contained in the USAF Stability and Control DATCOM, specifically those contained in sections 4, 5, 6 and 7.The work was performed by the McDonnell Douglas Corporation under contract with the United States Air Force in conjunction with engineers at the Air Force Flight Dynamics Laboratory in Wright-Patterson Air Force Base.
The flight deck control has three positions: off, automatic ("armed"), and manual (rarely used). On landing approach "automatic" is selected and, on touchdown, a sensor called a weight-on-wheels switch signals the lift dumpers to be raised. The flight control spoilers are also raised as additional lift dumpers.
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
An anti-servo tab on the elevator of an American Aviation AA-1 Yankee. An anti-servo tab, or anti-balance tab, works in the opposite way to a servo tab. It deploys in the same direction as the control surface, making the movement of the control surface more difficult and requires more force applied to the controls by the pilot.
A rudder pedal is a foot-operated aircraft flight control interface for controlling the rudder of an aircraft. [1] [2] The usual set-up in modern aircraft is that each pilot has a pedal set consisting of a pair of pedals, with one pedal for each foot. Each right and left pedal works together so that one pedal pops out when the other is ...
An approach plate for the ILS or LOC approach to runway 14L at Cologne Bonn Airport, Germany.. Approach plates (or, more formally, instrument approach procedure charts) are the printed or digital charts of instrument approach procedures that pilots use to fly instrument approaches during instrument flight rules (IFR) operations.