enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gastronorm - Wikipedia

   en.wikipedia.org/wiki/Gastronorm

   Containers usually come in standard depths of 20 mm, 40 mm, 65 mm, 100 mm, 150 mm, 200 mm. [5] Drain lids and lids with cut-outs such that a serving utensil can be placed into the container are common accessories. They are made in these sizes especially for the catering industry.

3. Kitchen work triangle - Wikipedia

   en.wikipedia.org/wiki/Kitchen_Work_Triangle

   The kitchen work triangle principle is used by kitchen designers and architects when designing residential kitchens. Recommended dimensions and layouts will vary with different building codes around the world, but some examples are: [4] [5] No leg of the triangle should be less than 1.2 m (4 ft) or more than 2.7 m (9 ft).

4. Air gap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Air_gap_(plumbing)

   This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...

5. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...

6. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   ISO general purpose metric screw threads – Part 9: Nominal sizes for 4 mm fine pitch threads; nominal diameter from 40 mm to 300 mm: Active: DIN 13-10: ISO general purpose metric screw threads – Part 10: Nominal sizes for 6 mm fine pitch threads; nominal diameter from 70 mm to 500 mm: Active: DIN 13-11

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...