enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...

3. 10BASE2 - Wikipedia

   en.wikipedia.org/wiki/10BASE2

   10BASE2 (also known as cheapernet, [1] thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors to build a local area network. During the mid to late 1980s, this was the dominant 10 Mbit/s Ethernet standard.

4. Fiber media converter - Wikipedia

   en.wikipedia.org/wiki/Fiber_media_converter

   A Fast Ethernet fiber converter (100BASE-FX using ST connector to 100BASE-TX using modular connector). A fiber media converter is a simple networking device that makes it possible to connect two dissimilar media types such as twisted pair with fiber optic cabling.

5. Fast Ethernet - Wikipedia

   en.wikipedia.org/wiki/Fast_Ethernet

   Fast Ethernet is an extension of the 10-megabit Ethernet standard. It runs on twisted pair or optical fiber cable in a star wired bus topology , similar to the IEEE standard 802.3i called 10BASE-T , itself an evolution of 10BASE5 (802.3) and 10BASE2 (802.3a).

6. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...

7. Gigabit Ethernet - Wikipedia

   en.wikipedia.org/wiki/Gigabit_Ethernet

   The initial standard for Gigabit Ethernet was produced by the IEEE in June 1998 as IEEE 802.3z, and required optical fiber. 802.3z is commonly referred to as 1000BASE-X, where -X refers to either -CX, -SX, -LX, or (non-standard) -ZX. (For the history behind the "X" see Fast Ethernet § Nomenclature.)