Search results
Results from the WOW.Com Content Network
It consists of an electroless nickel plating, covered with a thin layer of gold, which protects the nickel from oxidation. The gold is typically applied by quick immersion in a solution containing gold salts. Some of the nickel is oxidized to Ni 2+ while the gold is reduced to metallic state. A variant of this process adds a thin layer of ...
Plating is a finishing process in which a metal is deposited on a surface. Plating has been done for hundreds of years; it is also critical for modern technology. Plating is used to decorate objects, for corrosion inhibition, to improve solderability, to harden, to improve wearability, to reduce friction, to improve paint adhesion, to alter conductivity, to improve IR reflectivity, for ...
Most electrical connectors have a gender – i.e. the male component, called a plug, connects to the female component, or socket. Thousands of configurations of connectors are manufactured for power, data, and audiovisual applications. [3] Electrical connectors can be divided into four basic categories, differentiated by their function: [4]
Many types of Berg connectors exist. Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in ...
Electroless nickel plating also can produce coatings that are free of built-in mechanical stress, or even have compressive stress. [ 16 ] A disadvantage is the higher cost of the chemicals, which are consumed in proportion to the mass of nickel deposited; whereas in electroplating the nickel ions are replenished by the metallic nickel anode.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
Nickel electroplating is a process of depositing nickel onto a metal part. Parts to be plated must be clean and free of dirt, corrosion, and defects before plating can begin. [3] To clean and protect the part during the plating process, a combination of heat treating, cleaning, masking, pickling, and etching may be used. [1]
Traditionally these connectors have been used with flat cable which makes it easy to ensure the correct conductors go into the correct slots. Modular connectors used with Category 5 twisted pair cable require careful arranging of the conductors by hand before inserting them into the connector.