Search results
Results from the WOW.Com Content Network
On low-slope asphalt roofs, ponding water allows the oil solvent components of the asphalt to leach out and evaporate, leaving the roof membrane brittle and susceptible to cracking and leaking in the ponding location. [1] The time taken for water to saturate a zone, usually from rainfall, causing a pond to form, is referred to as the "ponding ...
Mechanically seamed metal with concealed fasteners contains sealant in seams for use on very low sloped roofs, suitable for roofs of low pitch such as 0.5/12 to 3/12 pitch. Flat-seam metal with or without soldered seams. Steel coated with a coloured alloy of zinc and aluminium. Stone-coated metal roofing.
Flat roofs, or "low-slope" roofs, are also commonly found on commercial buildings throughout the world. The U.S.-based National Roofing Contractors Association defines a low-slope roof as having a slope of 3 in 12 (1:4) or less. [2] Flat roofs exist all over the world, and each area has its own tradition or preference for materials used.
Asphalt roll roofing or membrane is a roofing material commonly used for buildings that feature a low sloped roof pitch in North America. The material is based on the same materials used in asphalt shingles ; an organic felt or fiberglass mat, saturated with asphalt , and faced with granular stone aggregate.
Flat roofs actually slope up to approximately ten degrees to shed water. Flat roofs on houses are primarily found in arid regions. [2] In high-wind areas, such as where a cyclone or hurricane may make landfall, the main engineering consideration is to hold the roof down during severe storms. Every component of the roof, as of course the rest of ...
Decks are often built from pressure-treated wood. Pressure-treated wood is long lasting and holds up to wet and icy conditions. Pressure-treating chemicals are known to be toxic. [2] Both softwood and hardwood decks need to be finished after installation using either an oil or varnish to prevent weathering, wear, mould, algae and wood-boring ...
A flat roof includes pitches as low as 1 ⁄ 2:12 to 2:12 (1 in 24 to 1 in 6), which are barely capable of properly shedding water. Such low-slope roofs (up to 4:12 (1 in 3)) require special materials and techniques to avoid leaks. [4] Conventional describes pitches from 4:12 (1 in 3) to 9:12 (3 in 4). [4]
In some cases, a cricket can be used to transition from one roof area to another. On low-slope and flat roofs with parapet walls, crickets are commonly used to divert water to the drainage, against or perpendicular to the main roof slope. The pitch of a cricket is sometimes the same as the rest of the roof, but not always. For Steep-slope roofs ...