Search results
Results from the WOW.Com Content Network
The Cheng cycle is a simplified form of combined cycle where the steam turbine is eliminated by injecting steam directly into the combustion turbine. This has been used since the mid 1970s and allows recovery of waste heat with less total complexity, but at the loss of the additional power and redundancy of a true combined cycle system.
Cogeneration or combined heat and power (CHP) is the use of a heat engine [1] or power station to generate electricity and useful heat at the same time. Cogeneration is a more efficient use of fuel or heat, because otherwise-wasted heat from electricity generation is put to some productive use.
The curve plots 501F combined cycle efficiency vs. time, with simple cycle power rating and heat rate shown at intervals along the development timeline. (Ed. Note: As of this edit in 2016, MHI offers the M501F3 at 185 MW and Siemens offers the SGT6-5000F (a.k.a. 501F) at 242MW, approximately the rating of the original 501G, below.)
Gas turbine (Brayton cycle) thermal plants require around 15-30 minutes to startup. Coal thermal plants based on steam turbines (Rankine cycle) are dispatchable sources that require hours to startup. The combined cycle power plants consist of few stages with varying startup times with more than 8 hours required to get to full power from cold ...
Mohave Generating Station, a 1,580 MW steam–electric power plant near Laughlin, Nevada fuelled by coal. A steam–electric power station is a power station in which the electric generator is steam-driven: water is heated, evaporates, and spins a steam turbine which drives an electric generator.
Load-following power plants can be hydroelectric power plants, diesel and gas engine power plants, combined cycle gas turbine power plants and steam turbine power plants that run on natural gas or heavy fuel oil, although heavy fuel oil plants make up a very small portion of the energy mix. A relatively efficient model of gas turbine that runs ...
Real-world systems claim a maximum thermal to electrical conversion efficiency of 23-35% for "power tower" type systems, operating at temperatures from 250 to 565 °C, with the higher efficiency number assuming a combined cycle turbine. Dish Stirling systems, operating at temperatures of 550-750 °C, claim an efficiency of about 30%, [97] with ...
Large (land-based) electric powerplants built using this combined cycle can reach conversion efficiencies of over 60%. [ 1 ] If the turbines do not drive a propeller shaft directly and instead a turbo-electric transmission is used, the system is known as COGES (combined gas turbine-electric and steam).