Ads
related to: honeywell timer instruction manualget.usermanualsonline.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
The Honeywell 6000 series computers were rebadged versions of General Electric's 600-series mainframes manufactured by Honeywell International, Inc. from 1970 to 1989. . Honeywell acquired the line when it purchased GE's computer division in 1970 and continued to develop them under a variety of names for m
The Datamatic Division of Honeywell announced the H-800 electronic computer in 1958. The first installation occurred in 1960. A total of 89 units were delivered. The H-800 design was part of a family of 48-bit word, three-address instruction format computers that descended from the Datamatic 1000, which was a joint Honeywell and Raytheon project started in 1955.
Honeywell electronic thermostat in a store. Heating and cooling losses from a building (or any other container) become greater as the difference in temperature increases. A programmable thermostat allows reduction of these losses by allowing the temperature difference to be reduced at times when the reduced amount of heating or cooling would not be objectionable.
A time switch (also called a timer switch, or simply timer) is a device that operates an electric switch controlled by a timer. Intermatic introduced its first time switch in 1945, which was used for "electric signs, store window lighting, apartment hall lights, stokers, and oil and gas burners." A consumer version was added in 1952. [1]
Honeywell was the U.S. importer of the Spotmatic. Cameras officially imported by Honeywell were labeled Honeywell Pentax, instead of Asahi Pentax. The Spotmatic IIa was only available as a Honeywell Pentax; it was sold exclusively in the US and had an electronic interface for specific Honeywell Strobonar electronic flash units.
SBC 11/21 (boardname KXT11) Falcon and Falcon Plus – single board computer on a Q-Bus card implementing the basic PDP–11 instruction set, based on T11 chipset containing 32 KB static RAM, two ROM sockets, three serial lines, 20 bit parallel I/O, three interval timers and a two-channel DMA controller.
A Hobbs Meter made by General Electric about 1970. Hobbs meter is a generic trademark for devices used in aviation to measure the time that an aircraft is in use. The meters typically display hours and tenths of an hour, but there are several ways in which the meter may be activated:
Control Data Corporation (CDC) was a mainframe and supercomputer company that in the 1960s was one of the nine major U.S. computer companies, which group included IBM, the Burroughs Corporation, and the Digital Equipment Corporation (DEC), the NCR Corporation (NCR), General Electric, and Honeywell, RCA and UNIVAC.
Ads
related to: honeywell timer instruction manualget.usermanualsonline.com has been visited by 10K+ users in the past month