Search results
Results from the WOW.Com Content Network
Pressure piling is a phenomenon related to combustion of gases in a tube or long vessel. When a flame front propagates along a tube, the unburned gases ahead of the front are compressed, and hence heated. The amount of compression varies depending on the geometry and can range from twice to eight times the initial pressure.
The dry concrete plug was not introduced to the design until 1926. [2] Before this innovation, the casing had to be top-driven and equipped with a lost bottom plate. [1] The Franki pile with vibrated shaft and hydraulic vibrating hammer were manufactured starting from 1960 and 1971 respectively. [2]
[2] The most common form of pile driver uses a heavy weight situated between vertical guides placed above a pile. The weight is raised by some motive power (which may include hydraulics, steam, diesel, electrical motor, or manual labor). At its apex the weight is released, impacting the pile and driving it into the ground. [1] [3]
In jet piling high pressure water is used to set piles. [8] High pressure water cuts through soil with a high-pressure jet flow and allows the pile to be fitted. [9] One advantage of Jet Piling: the water jet lubricates the pile and softens the ground. [10] The method is in use in Norway. [11]
A suction caisson can effectively be described as an inverted bucket that is embedded in the marine sediment.Attachment to the sea bed is achieved either through pushing or by creating a negative pressure inside the caisson skirt by pumping water out of the caisson; both of these techniques have the effect of securing the caisson into the sea bed.
Screw piles were first described by the Irish civil engineer Alexander Mitchell in a paper in Civil Engineer and Architect's Journal in 1848; however, helical piles had been used for almost a decade by this point. [2] Screw foundations first appeared in the 1800s as pile foundations for lighthouses, [3] and were extensively used for piers in ...
Nuclear radiation, or gamma-gamma method [3] Short wave (ultrasonic) acoustic method [4] Long wave (sonic) acoustic method [5] A pile integrity test (also known as low-strain dynamic test, sonic echo test, and low-strain integrity test) is one of the methods for assessing the condition of piles or shafts. It is cost-effective and not very time ...
Dynamic load testing (or dynamic loading) is a method to assess a pile's bearing capacity by applying a dynamic load to the pile head (a falling mass) while recording acceleration and strain on the pile head. Dynamic load testing is a high strain dynamic test which can be applied after pile installation for concrete piles. For steel or timber ...