Search results
Results from the WOW.Com Content Network
A typical datum reference frame is made up of three planes. For example, the three planes could be one "face side" and two "datum edges". These three planes are marked A, B and C, where A is the face side, B is the first datum edge, and C is the second datum edge. In this case, the datum reference frame is A/B/C.
computer-aided design, computer-aided drafting; cadmium [plating] CAGE: Commercial and Government Entity [code] A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes ...
An example of a multiview orthographic drawing from a US Patent (1913), showing two views of the same object. Third angle projection is used. In third-angle projection , the object is conceptually located in quadrant III, i.e. it is positioned below and behind the viewing planes, the planes are transparent , and each view is pulled onto the ...
For instance: the pattern of cells in Taylor–Couette flow varies along the azimuth of the experiment. Tangential – intersecting a curve at a point and parallel to the curve at that point. Collinear – in the same line; Parallel – in the same direction. Transverse – intersecting at any angle, i.e. not parallel.
A drawing the intended locations of plant items and service routes in such detail as to indicate the design intent. The main features of detailed design drawings should be as follows: Plan layouts to a scale of at least 1:100. Plant areas to a scale of at least 1:50 and accompanied by cross-sections.
The original feature of the patent was what is now called tube-over-bar (TOB) design which only saw limited use in the 1960s (for example, on LVTP-7). Even though Barnes was employed by the US Army Ordnance Department, torsion bars were not used in American armor designs until the T70 GMC in 1943, which suspension was derived from Pz. III by GM ...
The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...
In the manufacture of cloth, warp and weft are the two basic components in weaving to transform thread and yarn into textile fabrics. The vertical warp yarns are held stationary in tension on a loom (frame) while the horizontal weft (also called the woof) is drawn through (inserted over and under) the warp thread. [1]