enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   Sheet metal screws (sometimes called "sheet-metal self-tappers", P–K or PK screws from the brand name Parker Kalon, the company which pioneered [7] the manufacture of, but did not invent, these screws) are a type of screw which can form a thread in thin sheet metal. Pan-head self-tapping screws are common in metal cases for electrical ...

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   self-drilling screw Tek screw: Similar to a sheet metal screw, but it has a drill-shaped point to cut through the substrate to eliminate the need for drilling a pilot hole. Designed for use in soft steel or other metals. The points are numbered from 1 through 5; the larger the number, the thicker metal it can go through without a pilot hole.

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).

5. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.

6. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

7. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Instead, a one-way screw can be removed by drilling a hole through the head of the screw and inserting a screw extractor. Alternatively, a rotary tool with cutting disk can be used to extend the slot, the head can be gripped with locking pliers , or the screw can be removed with a pin spanner (snake-eyes driver) after drilling two holes in the ...