Search results
Results from the WOW.Com Content Network
An attic fan installed underneath a roof. A powered attic ventilator, or attic fan, is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used. An attic fan can be gable mounted or roof mounted. Additional ...
Isothermalize a natural convection heat sink, increasing its efficiency and reducing its size. In one case, adding five heat pipes reduced the heat sink mass by 34%, from 4.4 kg to 2.9 kg. [7] Efficiently transform the high heat flux directly under an LED to a lower heat flux that can be removed more easily. [8]
The furnace, built on the outside of the workshop, featured earthen pipe-like air vents with hundreds of tiny holes in them and a prototype chimney to ensure air goes into the furnace to feed the fire and smoke comes out safely. [39] Passive ventilation and passive cooling systems were widely written about around the Mediterranean by Classical ...
Ceiling-mounted: Mounted in the ceiling between the attic and living space. Ducted: Remotely mounted away from the ceiling, typically hung from the rafters; can exhaust heat from multiple locations; operation is usually quiet compared to traditional whole-house fans. Window-mounted: Mounted in a window frame. Can also take cool air in from outside.
A register is a grille with moving parts, capable of being opened and closed and the air flow directed, which is part of a building's heating, ventilation, and air conditioning (HVAC) system. The placement and size of registers is critical to HVAC efficiency. Register dampers are also important, and can serve a safety function.
The majority of guidance available for design of heat and smoke building vents installed in buildings is restricted to nonsprinklered, single-story buildings. [4] This is partly a historical consequence of the installation of heat and smoke vents following the August 1953 General Motors, Livonia, MI major fire in a nonsprinklered manufacturing facility which effectively stopped the production ...
Louvered attic vent in a gable Modern building codes permit both vented and unvented attics in all climates, if a building is otherwise correctly constructed. [ 5 ] However, unoccupied attics should usually be ventilated [ 6 ] to reduce the accumulation of heat and moisture that contribute to mold growth and decay of wood rafters and ceiling ...
Ducts for air pollution control in a 17000 standard cubic feet per minute regenerative thermal oxidizer (RTO). A round galvanized steel duct connecting to a typical diffuser Fire-resistance rated mechanical shaft with HVAC sheet metal ducting and copper piping, as well as "HOW" (Head-Of-Wall) joint between top of concrete block wall and underside of concrete slab, firestopped with ceramic ...