enow.com Web Search

  1. Ad

    related to: parts of floppy drive cable

Search results

  1. Results from the WOW.Com Content Network
  2. Floppy disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk_drive_interface

    These cables still only supported two drives, one before and one after the twist, but they allowed using one cable for any combination of drives with differing connectors. This type of cable is called a universal cable. [8] When multiple floppy disks are connected, many pins are shared, including the read and write data pins.

  3. Berg connector - Wikipedia

    en.wikipedia.org/wiki/Berg_connector

    Rear side of 3.5-inch floppy drive. Berg connector for power is shown on the left; data cable on right. Berg connector is a brand of electrical connector used in computer hardware. Berg connectors are manufactured by Berg Electronics Corporation of St. Louis, Missouri, now part of Amphenol.

  4. Ribbon cable - Wikipedia

    en.wikipedia.org/wiki/Ribbon_cable

    A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm). These types are used for many types of equipment, in particular for interconnections within an enclosure. For personal computers, this size was used in floppy-disk-drive cables and older or custom Parallel ATA cables.

  5. Floppy-disk controller - Wikipedia

    en.wikipedia.org/wiki/Floppy-disk_controller

    When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.

  6. Molex connector - Wikipedia

    en.wikipedia.org/wiki/Molex_connector

    The first 5.25-inch floppy disk drive, the Shugart SA400, introduced in August 1976, used the AMP Mate-n-Lok connector part number 350211-1. [4] This connector became the standard for 5.25-inch format peripherals such as hard drives and was used until introduction of SATA drives.

  7. Parallel ATA - Wikipedia

    en.wikipedia.org/wiki/Parallel_ATA

    Some operating systems required code changes to support floppy disks with capacities far larger than any standard floppy disk drive. Also, standard-floppy disk drive emulation proved to be unsuitable for certain high-capacity floppy disk drives such as Iomega Zip drives. Later the ARMD-HDD, ARMD-"Hard disk device", variant was developed to ...

  8. File:Floppy disk internal diagram.svg - Wikipedia

    en.wikipedia.org/wiki/File:Floppy_disk_internal...

    English: Diagram illustrating the basic internal parts of a 3.5" floppy disk. Document labels rendered as numbers to aid in internationalization. Note: The unlabeled square in the upper left is the approximate location of the write protection tab.

  9. D-subminiature - Wikipedia

    en.wikipedia.org/wiki/D-subminiature

    DB-19 connector for an external floppy drive on a Macintosh 512K The early Macintosh and late Apple II computers used a non-standard 19-pin D-sub for connecting external floppy disk drives. Atari also used this connector on their 16-bit computer range for attaching hard disk drives and the Atari laser printer , where it was known as both the ...

  1. Ad

    related to: parts of floppy drive cable