Search results
Results from the WOW.Com Content Network
The electronic sensor in the controller cabinet senses the change in the magnetic field. The output from the sensor electronics is a 'switch' closure. This can be an electro-mechincial relay or solid-state. The 'switch' is normally closed (NC) in the de-engerized state but held open when power is applied to the circuit.
The time and distance registers are completely separate from each other, and each is controlled by a toggle switch, which is operated by the traffic officer. To clock the patrol vehicle's speed (for instance, when the speed is matched with the violator's vehicle), both switches are operated simultaneously.
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
Reducing collisions and waiting time for both vehicles and pedestrians [20] Encouraging travel within the speed limit to meet green lights; Reducing unnecessary stopping and starting of traffic - this in turn reduces fuel consumption, air and noise pollution, and vehicle wear and tear; Reducing travel time; Reducing driver frustration and road rage
Adaptive cruise control does not provide full autonomy: the system only provides some help to the driver, but does not drive the car by itself. [3] For example, the driver is able to set the cruise control to 55mph, if the car while traveling that speed catches up to another vehicle going only 45mph, the ACC will cause the car to automatically brake and maintain a safe distance behind the ...
The participating vehicle acts itself consequently as a moving sensor using an onboard GPS receiver or cellular phone. The most common and widespread use of FCD is to determine the traffic speed on the road network. Based on these data, traffic congestion can be identified, travel times can be calculated, and traffic reports can
Hall sensors are commonly used to time the speed of wheels and shafts (e.g. Figure 1), such as for internal combustion engine ignition timing, tachometers and anti-lock braking systems. Common applications are often found where a robust and contactless alternative to a mechanical switch or potentiometer is required.
The cruise control takes its speed signal from a rotating driveshaft, speedometer cable, wheel speed sensor from the engine's RPM, or internal speed pulses produced electronically by the vehicle. Most systems do not allow the use of the cruise control below a certain speed - typically around 25 or 30 mph (40 or 48 km/h).