Search results
Results from the WOW.Com Content Network
The electronic sensor in the controller cabinet senses the change in the magnetic field. The output from the sensor electronics is a 'switch' closure. This can be an electro-mechincial relay or solid-state. The 'switch' is normally closed (NC) in the de-engerized state but held open when power is applied to the circuit.
The driver must manually bring the vehicle up to speed and use a button to set the cruise control to the current speed. The cruise control takes its speed signal from a rotating driveshaft, speedometer cable, wheel speed sensor from the engine's RPM, or internal speed pulses produced electronically by the vehicle. Most systems do not allow the ...
The time and distance registers are completely separate from each other, and each is controlled by a toggle switch, which is operated by the traffic officer. To clock the patrol vehicle's speed (for instance, when the speed is matched with the violator's vehicle), both switches are operated simultaneously.
The cycle time is the time it takes for a cycle to complete. Some jurisdictions have maximum cycle times. For example, in the UK this is 120 seconds or 90 seconds where pedestrian facilities are present. Under actuated control, the reversion is the stage which the traffic controller will return to if there is no demand. [4]
The ECM is a type of electronic control unit (ECU), which is an embedded system that employs software to determine the required throttle position by calculations from data measured by other sensors, including the accelerator pedal position sensors, engine speed sensor, vehicle speed sensor, and cruise control switches.
Adaptive cruise control does not provide full autonomy: the system only provides some help to the driver, but does not drive the car by itself. [3] For example, the driver is able to set the cruise control to 55mph, if the car while traveling that speed catches up to another vehicle going only 45mph, the ACC will cause the car to automatically brake and maintain a safe distance behind the ...
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
The engine control unit can then calculate engine speed (angular velocity). Speed sensors used in automobile transmissions are used to measure the rotational speed (angular velocity) of shafts within the transmission. The engine control unit or transmission control unit (depending on the particular automobile) uses these sensors to determine ...