Search results
Results from the WOW.Com Content Network
Layer 2 Tunneling Protocol version 3 is an IETF standard related to L2TP that can be used as an alternative protocol to Multiprotocol Label Switching (MPLS) for encapsulation of multiprotocol Layer 2 communications traffic over IP networks. [1] Like L2TP, L2TPv3 provides a pseudo-wire service, but scaled to fit carrier requirements.
This is carried out over UDP port 500, and commonly uses either a shared password (so-called "pre-shared keys"), public keys, or X.509 certificates on both ends, although other keying methods exist. Establishment of Encapsulating Security Payload (ESP) communication in transport mode. The IP protocol number for ESP is 50 (compare TCP's 6 and ...
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header.It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header.
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic. TCP usually uses port numbers that match the services of the corresponding UDP implementations, if they exist, and vice versa.
Tunneling a TCP-encapsulating payload (such as PPP) over a TCP-based connection (such as SSH's port forwarding) is known as "TCP-over-TCP", and doing so can induce a dramatic loss in transmission performance — known as the TCP meltdown problem [6] [7] which is why virtual private network (VPN) software may instead use a protocol simpler than ...
L2F, or Layer 2 Forwarding, is a tunneling protocol developed by Cisco Systems, Inc. to establish virtual private network connections over the Internet. L2F does not provide encryption or confidentiality by itself; It relies on the protocol being tunneled to provide privacy .
In contrast to L2TPv3, which allows only point-to-point layer 2 tunnels, VPLS allows any-to-any (multipoint) connectivity. In a VPLS, the local area network (LAN) at each site is extended to the edge of the provider network. The provider network then emulates a switch or bridge to connect all of the customer LANs to create a single bridged LAN.