Search results
Results from the WOW.Com Content Network
The Buick V6 is an OHV V6 engine developed by the Buick division of General Motors and first introduced in 1962. The engine was originally 198 cu in (3.2 L) and was marketed as the Fireball engine. GM continued to develop and refine the 231 cu in (3.8 L) V6, eventually and commonly referred to simply as the 3800, through numerous iterations.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...
By the mid-1990s, the 4T60-E was the transmission of choice in nearly every front-wheel drive GM vehicle with the exception of compacts. A heavy-duty 4T60-E HD was produced in 1996 for the supercharged GM 3800 engine and reused in mid 2005 to 2009 with an LS4 5.3 liter V8 in four different models the Buick Lacrosse Super, Chevrolet Impala SS ...
The General Motors 60° V6 engine family is a series of 60° V6 engines produced for both longitudinal and transverse applications. All of these engines are 12-valve cam-in-block or overhead valve engines, except for the LQ1 which uses 24 valves driven by dual overhead cams. These engines vary in displacement between 2.8 and 3.4 litres (2,837 ...
The 90° V6 engine uses the same transmission bellhousing pattern as the Chevrolet small-block V8 engine. The oil pan dipstick is located on the passenger side above the oil pan rail; this design was phased in on both the 90° V6 and Small Block Chevrolet assembly lines (for engines manufactured after 1979) sharing the same casting dies.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
The metric 200 three-speed automatic transmission became standard on all models and a new Chevrolet-built 229 cu in (3.8 L) V6 with 2-barrel Rochester carburetor replaced both the 200 cu in (3.3 L) V6 of 1979 and the Buick engine offered on all 1978 models and the 1979 Landau as the standard engine in 49 states (California cars continued to use ...