enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.

4. Corrugated stainless steel tubing - Wikipedia

   en.wikipedia.org/wiki/Corrugated_stainless_steel...

   Presently, CSST and FAC tubing both use corrugated stainless steel tubing. In the past, FAC used corrugated brass tubing. However, FAC tubing is made only in lengths of 1 to 6 feet, FAC tubing is made with connectors on each end, and FAC tubing does not have a plastic sheath. On FAC tubing the corrugations are visible.

5. Stainless steel - Wikipedia

   en.wikipedia.org/wiki/Stainless_steel

   Stainless steel, also known as inox, corrosion-resistant steel (CRES), and rustless steel, is an iron-based alloy containing a minimum level of chromium that is resistant to rusting and corrosion. Stainless steel's resistance to corrosion results from the 10.5%, or more, chromium content which forms a passive film that can protect the material ...

6. Tube (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Tube_(fluid_conveyance)

   A tube and pipe may be specified by standard pipe size designations, e.g., nominal pipe size, or by nominal outside or inside diameter and/or wall thickness. The actual dimensions of pipe are usually not the nominal dimensions: A 1-inch pipe will not actually measure 1 inch in either outside or inside diameter, whereas many types of tubing are ...

7. Cathodic protection - Wikipedia

   en.wikipedia.org/wiki/Cathodic_protection

   The test differed from the ASTM B117 insofar as the galvanized automotive steel panels were not entirely exposed to the salt spray. Instead, only the bare steel exposed by a 12-inch scratch at one end of the panel was exposed to the salt spray while the remainder of the panel was kept in a completely dry condition. [53]

8. Stopper (plug) - Wikipedia

   en.wikipedia.org/wiki/Stopper_(plug)

   With tubing inserted into the hole(s), when the tube is heated, water vapor will rise through the hole, make its way through the tubing, and into the collection chamber of choice. The water vapor would not be able to escape into the air, because the stopper and the tubing, if set up correctly, would be airtight. [citation needed]

9. Fisher-Porter tube - Wikipedia

   en.wikipedia.org/wiki/Fisher-Porter_tube

   The advantage over steel autoclaves is that the progress of a reaction can be followed by eye. The maximum pressure that can be achieved is much lower than that in a metal bomb . For example, typical pressure ratings are 7 bar for a large 335 mL Fisher-Porter vessel and 15 bar for a small 90 mL one, whereas the usual kind of bomb is safe to use ...