Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are ...
"MCA" stood for "Mitsubishi Clean Air", reflecting Japan's new air quality laws. The MCA-II was cleaner yet, and with balance shafts it also offered a much smoother run, at the loss of a few horsepower. The Sports engine did not meet the stricter emissions laws, which led to the demise of the Skipper.
The rocker arms for the intake valve were widened on the valve end to accommodate the cartridge, which was equipped with a very soft valve spring in order to avoid wear on the camshaft intake lobe. Modifications to the head were thereby reduced as the Jet Valve negated the necessity for a three-valve-per-cylinder design. [2]
Those with the later, cleaner yet, "MCA-Jet" system were called G32B. Later, the G32B also came in a fuel injected , turbocharged model. For competition, a version of the 4G32 engine was made with a DOHC eight-valve cylinder head, and fitted with two twin-choke 40 mm (1.6 in) Solex sidedraft carburettors.
This version could switch between breathing through two or three valves per cylinder, to combine high top-end power with low-end drivability as well as allowing for economical operation. [1] It was a modification of Mitsubishi MCA-Jet technology which used a secondary intake valve to inject air into the engine for more efficient emissions ...
Using the PRV method of control, means that the pressure of the feed oil must be below a critical value (usually controlled by other valves which can leak out excess oil back to tank if it exceeds the critical value). The valve opens at a certain pressure and oil is kept moving at a constant rate into the bearing chamber.
The quantity of bleed air flowing to the AC pack is regulated by the flow control valve (FCV). One FCV is installed for each PACK. A normally closed isolation valve prevents air from the left bleed system from reaching the right PACK (and vice versa), although this valve may be opened in the event of loss of one bleed system.
Electrical engineering – Electrical engineering is an engineering discipline concerned with the study, design and application of equipment, devices and systems which use electricity, electronics, and electromagnetism. Electrical circuit – an electrical network consisting of a closed loop, giving a return path for the current.