enow.com Web Search

  1. Ads

    related to: control cable vs power supply

Search results

  1. Results from the WOW.Com Content Network
  2. Power supply unit (computer) - Wikipedia

    en.wikipedia.org/wiki/Power_supply_unit_(computer)

    Thus, the cables of a modular power supply must only be used with this particular modular power supply model. Usage with another modular power supply, even if the cable prima facie appear compatible, might result in a wrong pin assignment and thus can lead to damage of connected components by supplying 12V to a 5V or 3.3V pin. [33]

  3. Power supply - Wikipedia

    en.wikipedia.org/wiki/Power_supply

    An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...

  4. Power over Ethernet - Wikipedia

    en.wikipedia.org/wiki/Power_over_Ethernet

    Power is supplied as a common-mode signal over two or more of the differential pairs of wires found in the Ethernet cables and comes from a power supply within a PoE-enabled networking device such as an Ethernet switch or can be injected into a cable run with a midspan power supply, an additional PoE power source that can be used in combination ...

  5. Switched-mode power supply - Wikipedia

    en.wikipedia.org/wiki/Switched-mode_power_supply

    In contrast, a linear power supply regulates the output voltage by continually dissipating power in the pass transistor. The switched-mode power supply's higher electrical efficiency is an important advantage. Switched-mode power supplies can also be substantially smaller and lighter than a linear supply because the transformer can be much smaller.

  6. Distribution board - Wikipedia

    en.wikipedia.org/wiki/Distribution_board

    In a 96 dimmer rack, there are 32 dimmers on phase A, 32 dimmers on phase B, and 32 on phase C to spread out the lighting load as equally as possible. In addition to the power feed from the supply transformer in the building, a control cable from the lighting desk carries information to the dimmers in a control protocol such as DMX-512. The ...

  7. Sense (electronics) - Wikipedia

    en.wikipedia.org/wiki/Sense_(electronics)

    In electronics, sense is a technique used in power supplies to produce the correct voltage for a load.Although simple batteries naturally maintain a steady voltage (except in cases of large internal impedance), a power supply must use a feedback system to make adjustments based on the difference between its intended output and its actual output.

  1. Ads

    related to: control cable vs power supply