Search results
Results from the WOW.Com Content Network
All 1956 Mercury engines had gold-painted blocks and heads. The 210-horsepower version had red valve covers and air cleaner, while the 225-horsepower version had blue valve covers and air cleaner. The 235-horsepower version had argent silver valve covers and air cleaner. A dealer-installed "M 260" engine kit was released in January 1956.
The GT40P heads, unlike the GT40 heads, had a very well-developed port shape/design which yielded about 200 cfm on the intake side and 140 cfm on the exhaust side without increasing the size of the ports at all from standard E7TE castings, and without increasing the exhaust valve size. These highly-efficient heads also had smaller 59–61 cc ...
An automotive belt with the number "740K6" or "6K740" indicates a belt 74 inches (190 cm) in length, 6 ribs wide, with a rib pitch of 9 ⁄ 64 of an inch (3.6 mm) (a standard thickness for a K series automotive belt would be 4.5mm). A metric equivalent would be usually indicated by "6PK1880" whereby 6 refers to the number of ribs, PK refers to ...
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
These bore and stroke dimensions were later used by the 267 cu in (4.4 L) V8 Chevrolet engine. Also like the small block V8 engines, the 200 cu in (3.3 L) V6 used 2.45-inch (62.2 mm) main bearings and 2.1-inch (53.3 mm) rod bearing diameters. Being a 90° V6, Chevrolet took steps to eliminate the rough running tendencies of the 200.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
A single belt (serpentine belt) accessory drive was introduced on the L05, the 5.0L L03, and the 4.3L V6 LB4 engines used in the 1988 GMT400 models, but not on the older R/V models (R/V models received the serpentine belt drive in 1989 when the front grille was facelifted in appearance to the GMT400 lineup).
The LA engine is a family of overhead-valve small-block 90° V-configured gasoline engines built by Chrysler Corporation between 1964 and 2003. Primarily V8s , the line includes a single V6 and V10 , both derivations of its Magnum series introduced in 1992.