Search results
Results from the WOW.Com Content Network
In fluid dynamics, dynamic pressure (denoted by q or Q and sometimes called velocity pressure) is the quantity defined by: [1] = where (in SI units): q is the dynamic pressure in pascals (i.e., N/m 2, ρ (Greek letter rho) is the fluid mass density (e.g. in kg/m 3), and; u is the flow speed in m/s.
A valve stem is a self-contained valve that opens to admit gas to a chamber (such as air to inflate a tire), [1] and is then automatically closed and kept sealed by the pressure in the chamber, or a spring, [2] [3] or both, to prevent the gas from escaping.
The pressure value that is attempted to compute, is such that when plugged into momentum equations a divergence-free velocity field results. The mass imbalance is often also used for control of the outer loop. The name of this class of methods stems from the fact that the correction of the velocity field is computed through the pressure-field.
Limiting pressure velocity is a tribological term relating to the maximum temperature and compression that an assembly with rubbing surfaces can bear without failing. Pressure-limiting valves are a type of pressure control valve. They safeguard the system against excessive system pressure or limit the operation pressure.
The most common final control element in the process control industries is the control valve. The control valve manipulates a flowing fluid, such as gas, steam, water, or chemical compounds, to compensate for the load disturbance and keep the regulated process variable as close as possible to the desired set point. [1]
A rod is connected to the center of the diaphragm so that it moves as the pressure is applied. The rod is then connected to a valve stem which allows the valve to experience the linear motion thereby opening or closing. A diaphragm actuator is useful if the supply pressure is moderate and the valve travel and thrust required are low.
The mechanical feedback has been replaced by an electric feedback with a position transducer. Integrated electronics close the position loop for the spool. These valves are suitable for electrohydraulic position, velocity, pressure or force control systems with extremely high dynamic response requirements.
Simplified diagram of linear dashpot. A dashpot, also known as a damper [citation needed], is a mechanical device that resists motion via viscous friction. [1] The resulting force is proportional to the velocity, but acts in the opposite direction, [2] slowing the motion and absorbing energy.