Search results
Results from the WOW.Com Content Network
Pressurized walls are a type of wall that is installed without the use of nails or screws. The term is frequently used interchangeably with "temporary walls", "flex walls" and "partition walls" to refer to walls that can be installed and removed without modifying or damaging the existing property.
Temporary buildings on site during construction at Birmingham New Street station in 2011 North Isles Motel in Cunnister, Shetland. A portable, demountable or transportable building is a building designed and built to be movable rather than permanently located.
Portable walls are not generally anchored to a floor or ceiling, unlike suspended accordion room dividers, and drapes, pipe and drape. They are different from traditional office cubicles in that portable walls often serve a temporary function rather than a permanent workspace, such as use for art exhibits, classrooms, triage areas, trade show ...
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
Including house paint, plaster, wallpaper and wall upholstery Subcategories. This category has the following 7 subcategories, out of 7 total. A. Azulejo (5 C, 1 P) F.
Lincrusta wall covering, Roseland Cottage Detail of Byzantine pattern Lincrusta wall covering. Lincrusta is a deeply embossed wallcovering, invented by Frederick Walton. Walton was already known for patenting linoleum floor covering in 1860. [1] [2] Lincrusta was launched in 1877 and was used in a host of applications from royal homes to ...
A curtain wall is an exterior covering of a building in which the outer walls are non-structural, instead serving to protect the interior of the building from the elements. Because the curtain wall façade carries no structural load beyond its own dead load weight, it can be made of lightweight materials.
A typical temporary wall can be constructed with 1⁄2" (6 mm) to 5⁄8" (16 mm) sheet rock (plasterboard), metal 2 × 3s (approx. 5 × 7 cm), or 2 × 4s, or taped, plastered and compounded. Most installation companies use lattice (strips of wood) to cover the joints of the temporary wall with the ceiling.