Search results
Results from the WOW.Com Content Network
Electronic test equipment is used to create signals and capture responses from electronic devices under test (DUTs). In this way, the proper operation of the DUT can be proven or faults in the device can be traced. Use of electronic test equipment is essential to any serious work on electronics systems. Practical electronics engineering and ...
Measures current without physical connection. Curve tracer. Applies swept signals to a device and allows display of the response. Cos Phi Meter. Measures the power factor. Distortionmeter. Measures the distortion added to a circuit. Electricity meter. Measures the amount of energy dissipated.
Electrical measurements are the methods, devices and calculations used to measure electrical quantities. Measurement of electrical quantities may be done to measure electrical parameters of a system. Using transducers, physical properties such as temperature, pressure, flow, force, and many others can be converted into electrical signals, which ...
IEC 60642 Piezoelectric ceramic resonator units. IEC 60644 Specification for high-voltage fuse-links for motor circuit applications. IEC 60645 Electroacoustics – Audiometric equipment. IEC 60648 Method of test for coefficients of friction of plastic film and sheeting for use as electrical insulation.
Unlike the RTUs, IEDs are integrated with the devices they control and offer a standardized set of measuring and control points that is easier to configure and require less wiring. Most IEDs have a communication port and built-in support for standard communication protocols ( DNP3 , IEC104 or IEC61850), so they can communicate directly with the ...
Multimeter. Analog multimeter. Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2][3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).
The standard specifies a common syntax, command structure, and data formats, to be used with all instruments. It introduced generic commands (such as CONFigure and MEASure) that could be used with any instrument. These commands are grouped into subsystems. SCPI also defines several classes of instruments.