Search results
Results from the WOW.Com Content Network
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
Input with fractions: 1 + 1 ⁄ 2 inches (38.1 mm) The number to convert can be written in fractions. Both / (keyboard slash) and ⁄ (fraction slash) are accepted:
The US fluid ounce is based on the US gallon, which in turn is based on the wine gallon of 231 cubic inches that was used in the United Kingdom prior to 1824. With the adoption of the international inch , the US fluid ounce became 1 ⁄ 128 gal × 231 in 3 /gal × (2.54 cm/in) 3 = 29.5735295625 mL exactly, or about 4% larger than the imperial unit.
1.75:1 = 7:4 35 mm widescreen aspect ratio used by The Metro Goldwyn Mayer Company and The Warner Brothers Company from 1953 to 1955 and since abandoned and The Walt Disney Company has cropped the old classic post-1950s 1.33:1 fullscreen films to the 1.75:1 widescreen aspect ratio of their DVDs including The Jungle Book .
The first commonly available increase in tape length resulted from a reduction in backing thickness from 1.5 to 1.0 mil (38 to 25 μm) resulting in a total thickness reduction from 42 to 35 μm (1.7 to 1.4 mils), which allowed 3,600 ft (1,100 m), 1,800 ft (550 m), and 900 ft (270 m) tapes to fit on ten-and-a-half-, seven-, and five-inch reels respectively.
In the US, BSW was replaced when steel bolts replaced iron, but was still being used for some aluminium parts as late as the 1960s and 1970s when metric-based standards International Inch replaced the U.S. inch and U.K. inch in 1951-1964. [citation needed] American Unified Coarse (UNC) was originally based on almost the same Imperial fractions ...