Search results
Results from the WOW.Com Content Network
The triple-slotted trailing edge flaps are well displayed and the Krueger flaps on the leading edge also are visible. In aircraft design and aerospace engineering, a high-lift device is a component or mechanism on an aircraft's wing that increases the amount of lift produced by the wing. The device may be a fixed component, or a movable ...
Trailing edge flaps extended on the right on a typical airliner (an Airbus A310-300). Leading edge slats are also extended, on the left.. A flap is a high-lift device used to reduce the stalling speed of an aircraft wing at a given weight.
The angle between the upper and lower surfaces at the trailing edge is called the trailing edge angle. If the trailing edge angle is zero it is described as a cusped trailing edge. [5] In two-dimensional flow around a uniform wing of infinite span, the slope of the lift curve is determined primarily by the trailing edge angle. The slope is ...
Ailerons are mounted on the trailing edge of each wing near the wingtips and move in opposite directions. When the pilot moves the aileron control to the left, or turns the wheel counter-clockwise, the left aileron goes up and the right aileron goes down. A raised aileron reduces lift on that wing and a lowered one increases lift, so moving the ...
In 1958 he reworked that basic design, giving it an all-metal structure and increased power. The aircraft is a cantilever low-wing monoplane with plain ailerons and two-position trailing-edge flaps, conventional empennage, fixed nosewheel landing gear, and tandem seating. Dual controls are provided as standard equipment.
Slats are high-lift devices typically used on aircraft intended to operate within a wide range of speeds. Trailing-edge flap systems running along the trailing edge of the wing are common on all aircraft. The position of the leading-edge slats on an airliner (Airbus A310-300). In this picture, the slats are drooped.
In conjunction with the leading-edge slats, 74% of the trailing edge incorporates high-lift slotted flaps, which together with interrupter blades atop each wing when roll control is lost at very low airspeed, allows for a tight turning radius. The Helio Courier could maintain control at speeds as low as 27 miles per hour (43 km/h).
The Gurney flap (or wickerbill) is a small tab projecting from the trailing edge of a wing. Typically it is set at a right angle to the pressure-side surface of the airfoil [2] and projects 1% to 2% of the wing chord. [3] This trailing edge device can improve the performance of a simple airfoil to nearly the same level as a complex high ...