enow.com Web Search

  1. Ads

    related to: electronic car starter installation

Search results

  1. Results from the WOW.Com Content Network
  2. Remote starter - Wikipedia

    en.wikipedia.org/wiki/Remote_starter

    A remote starter is a radio controlled device, which is installed in a vehicle by the factory or an aftermarket installer to preheat or cool the vehicle before the owner gets into it. [1] Once activated, by pushing a button on a special key chain remote, it starts the vehicle automatically for a predetermined time.

  3. The 7 Best Remote Starters to Upgrade Your Ride - AOL

    www.aol.com/lifestyle/10-best-remote-starters...

    This remote starter only has a 1,000-foot-max range and many online DIY reviewers report that the wiring diagrams and installation instructions included with the system are incomplete.

  4. Starter (engine) - Wikipedia

    en.wikipedia.org/wiki/Starter_(engine)

    An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.

  5. Magnetic starter - Wikipedia

    en.wikipedia.org/wiki/Magnetic_starter

    A magnetic starter has a contactor and an overload relay, which will open the control voltage to the starter coil if it detects an overload on a motor. [1] [2] The overload relay opens a set of contacts that are wired in series with the supply to the contactor feeding the motor. The characteristics of the heaters can be matched to the motor so ...

  6. Automotive electronics - Wikipedia

    en.wikipedia.org/wiki/Automotive_electronics

    The earliest electronic systems available as factory installations were vacuum tube car radios, starting in the early 1930s.The development of semiconductors after World War II greatly expanded the use of electronics in automobiles, with solid-state diodes making the automotive alternator the standard after about 1960, and the first transistorized ignition systems appearing in 1963.

  7. Ignition coil - Wikipedia

    en.wikipedia.org/wiki/Ignition_coil

    Modern electronic ignition systems operate using the same principle of charging an electric circuit, however they use a capacitor charged to around 400 volts, [citation needed] rather than using the induction charging of an ignition coil. Typical output voltages for modern ignition coils vary from 15 kV (for a lawnmower engine) to 40 kV (for a ...

  1. Ads

    related to: electronic car starter installation