Search results
Results from the WOW.Com Content Network
When a program wants to time its own operation, it can use a function like the POSIX clock() function, which returns the CPU time used by the program. POSIX allows this clock to start at an arbitrary value, so to measure elapsed time, a program calls clock(), does some work, then calls clock() again. [1] The difference is the time needed to do ...
For example, with six executions units, six new instructions are fetched in stage 1 only after the six previous instructions finish at stage 5, therefore on average the number of clock cycles it takes to execute an instruction is 5/6 (CPI = 5/6 < 1). To get better CPI values with pipelining, there must be at least two execution units.
1 ns: The time light takes to travel 30 cm (11.811 in) 10 −6: microsecond: μs One millionth of one second 1 μs: The time needed to execute one machine cycle by an Intel 80186 microprocessor 2.2 μs: The lifetime of a muon 4–16 μs: The time needed to execute one machine cycle by a 1960s minicomputer: 10 −3: millisecond: ms One ...
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
The response time is the sum of three numbers: [3] Service time - How long it takes to do the work requested. Wait time - How long the request has to wait for requests queued ahead of it before it gets to run. Transmission time – How long it takes to move the request to the computer doing the work and the response back to the requestor.
time (Unix) - can be used to determine the run time of a program, separately counting user time vs. system time, and CPU time vs. clock time. [1] timem (Unix) - can be used to determine the wall-clock time, CPU time, and CPU utilization similar to time (Unix) but supports numerous extensions.
Profilers interrupt program execution to collect information, which may result in a limited resolution in the time measurements, which should be taken with a grain of salt. Basic block profilers report a number of machine clock cycles devoted to executing each line of code, or a timing based on adding these together; the timings reported per ...
The Time Stamp Counter was once a high-resolution, low-overhead way for a program to get CPU timing information. With the advent of multi-core/hyper-threaded CPUs, systems with multiple CPUs, and hibernating operating systems, the TSC cannot be relied upon to provide accurate results — unless great care is taken to correct the possible flaws: rate of tick and whether all cores (processors ...