Search results
Results from the WOW.Com Content Network
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport
A frame is "the unit of transmission in a link layer protocol, and consists of a link layer header followed by a packet." [2] Each frame is separated from the next by an interframe gap. A frame is a series of bits generally composed of frame synchronization bits, the packet payload, and a frame check sequence.
Generic 802.11 Frame. The very first two octets transmitted by a station are the Frame Control. The first three subfields within the frame control and the last field are always present in all types of 802.11 frames. These three subfields consist of two bits Protocol Version subfield, two bits Type subfield, and four bits Subtype subfield.
In the seven-layer OSI model of computer networking, packet strictly refers to a protocol data unit at layer 3, the network layer. [2] A data unit at layer 2, the data link layer, is a frame. In layer 4, the transport layer, the data units are segments and datagrams.
A non-uniform frame size configuration in the network using jumbo frames may be detected as jabber by end nodes. [citation needed] Jumbo frames are not part of the official IEEE 802.3 Ethernet standard. A packet detected as jabber by an upstream repeater and subsequently cut off has an invalid frame check sequence and is dropped. [65]
Individual frames are then "minor frames" within that superframe. Each frame contains a subframe ID (often a simple counter) which identifies its position within the superframe. A second frame synchronizer establishes superframe synchronization. This allows subcommutation, where some data is sent less frequently than every frame.
A 16-bit field set to a value of 0x8100 [b] in order to identify the frame as an IEEE 802.1Q-tagged frame. This field is located at the same position as the EtherType field in untagged frames, and is thus used to distinguish the frame from untagged frames. Tag control information (TCI) A 16-bit field containing the following sub-fields:
Jumbo frames have payloads greater than 1500 bytes. In computer networking, jumbo frames are Ethernet frames with more than 1500 bytes of payload, the limit set by the IEEE 802.3 standard. [1] The payload limit for jumbo frames is variable: while 9000 bytes is the most commonly used limit, smaller and larger limits exist.