Search results
Results from the WOW.Com Content Network
However, the names of all SI mass units are based on gram, rather than on kilogram; thus 10 3 kg is a megagram (10 6 g), not a *kilokilogram. The tonne (t) is an SI-compatible unit of mass equal to a megagram (Mg), or 10 3 kg. The unit is in common use for masses above about 10 3 kg and is often used with SI prefixes.
Pressure exerted by a 45 kg person wearing stiletto heels when a heel hits the floor [69] 15.5 Mpa 2,250 psi Primary coolant loop of a pressurized water reactor: 20 MPa 2,900 psi Typical pressure used for hydrogenolysis reactions [70] 21 MPa 3,000 psi Pressure of a typical aluminium scuba tank of pressurized air (210 bar) [71] 21 MPa 3,000 psi
Differential pressure is the difference in pressure between two points. Differential pressure sensors are used to measure many properties, such as pressure drops across oil filters or air filters, fluid levels (by comparing the pressure above and below the liquid) or flow rates (by measuring the change in pressure across a restriction ...
The standard state of a material (pure substance, mixture or solution) is a reference point used to calculate its properties under different conditions.A degree sign (°) or a superscript Plimsoll symbol (⦵) is used to designate a thermodynamic quantity in the standard state, such as change in enthalpy (ΔH°), change in entropy (ΔS°), or change in Gibbs free energy (ΔG°).
The CGS unit of pressure is the barye (Ba), equal to 1 dyn·cm −2, or 0.1 Pa. Pressure is sometimes expressed in grams-force or kilograms-force per square centimetre ("g/cm 2" or "kg/cm 2") and the like without properly identifying the force units. But using the names kilogram, gram, kilogram-force, or gram-force (or their symbols) as units ...
The relative activity of a species i, denoted a i, is defined [4] [5] as: = where μ i is the (molar) chemical potential of the species i under the conditions of interest, μ o i is the (molar) chemical potential of that species under some defined set of standard conditions, R is the gas constant, T is the thermodynamic temperature and e is the exponential constant.
The units of atmospheric pressure commonly used in meteorology were formerly the bar (100,000 Pa), which is close to the average air pressure on Earth, and the millibar. Since the introduction of SI units , meteorologists generally measure atmospheric pressure in hectopascals (hPa), equal to 100 pascals or 1 millibar.
A science fair or engineering fair is an event hosted by a school that offers students the opportunity to experience the practices of science and engineering for themselves. In the United States, the Next Generation Science Standards makes experiencing the practices of science and engineering one of the three pillars of science education.