Search results
Results from the WOW.Com Content Network
The electromagnetic lines of flux have to attract and pull the armature in contact with it to complete engagement. Most industrial couplings use what is called a single flux, two pole design (A-2). Mobile clutches of other specialty electromagnetic clutches can use a double or triple flux rotor (A-4).
The attraction of the armature compresses (squeezes) the friction disks, transferring the torque from the in inner driver to the out disks. The output disks are connected to a gear, coupling, or pulley via drive cup. The clutch slips until the input and output RPMs are matched. This happens relatively quickly typically (0.2 - 2 sec).
Another example of clutch usage is in electric drills. [2] The clutch's input shaft is driven by a motor and the output shaft is connected to the drill bit (via several intermediate components). The clutch allows the drill bit to either spin at the same speed as the motor (clutch engaged), spin at a lower speed than the motor (clutch slipping ...
A magnetic particle clutch is a special type of electromagnetic clutch which does not use friction plates. Instead, it uses a fine powder of magnetically susceptible material (typically stainless steel ) to mechanically link an otherwise free-wheeling disc attached to one shaft, to a rotor attached to the other shaft.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
Centrifugal clutches were used in railway locomotives before 1858, [1] and referred to (in relation to electric motors) in a patent of 1899. [2] A patent was issued in the United States for an automotive centrifugal clutch (on an electric vehicle) in 1898. [3] There is a design for a toy 'automatic clutch' in Meccano Magazine of June 1934. [4]
A cone clutch serves the same purpose as a disk or plate clutch; however, instead of mating two spinning disks, the cone clutch uses two conical surfaces to transmit torque by friction. [ 1 ] The cone clutch transfers a higher torque than plate or disk clutches of the same size due to the wedging action and increased surface area.