Search results
Results from the WOW.Com Content Network
In simple words, we can say that the partial pressure of a gas in vapour phase is directly proportional to the mole fraction of a gas in solution. An example where Henry's law is at play is the depth-dependent dissolution of oxygen and nitrogen in the blood of underwater divers that changes during decompression, going to decompression sickness.
The solubility of a specific solute in a specific solvent is generally expressed as the concentration of a saturated solution of the two. [1] Any of the several ways of expressing concentration of solutions can be used, such as the mass, volume, or amount in moles of the solute for a specific mass, volume, or mole amount of the solvent or of the solution.
Solvation or dissolution is a kinetic process and is quantified by its rate. Solubility quantifies the dynamic equilibrium state achieved when the rate of dissolution equals the rate of precipitation. The consideration of the units makes the distinction clearer. The typical unit for dissolution rate is mol/s.
These factors influence the transport of dissolved gases by diffusion and perfusion, and therefore affect the rate of uptake and elimination. [64] There are also effects due to bubble presence such as microparticles, oxidative stress, neutrophil activation, and endothelium damage. [60]
The solubility of gas obeys Henry's law, that is, the amount of a dissolved gas in a liquid is proportional to its partial pressure. Therefore, placing a solution under reduced pressure makes the dissolved gas less soluble. Sonication and stirring under reduced pressure can usually enhance the efficiency.
This difference arises from acid/base reactions between protic solvents (not aprotic solvents) and strong nucleophiles. While it is true that steric effects also affect the relative reaction rates, [12] however, for demonstration of principle for solvent polarity on S N 2 reaction rates, steric effects may be neglected.
The rate of dissolution will decrease substantially once it needs to penetrate through the pores of substance A in order to continue targeting substance B. [1] This penetration can often lead to dissolution of substance A, [1] or the product of more than one solute, [10] both unsatisfactory if specific leaching is desired.
A solubility equilibrium exists when a chemical compound in the solid state is in chemical equilibrium with a solution containing the compound. This type of equilibrium is an example of dynamic equilibrium in that some individual molecules migrate between the solid and solution phases such that the rates of dissolution and precipitation are equal to one another.