enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...

3. List of bicycle parts - Wikipedia

   en.wikipedia.org/wiki/List_of_bicycle_parts

   Brake: devices used to stop or slow down a bicycle. Rim brakes and disc brakes are operated by brake levers, which are mounted on the handlebars. Band brake is an alternative to rim brakes but can only be installed at the rear wheel. Coaster brakes are operated by pedaling backward; Brake lever: a lever for actuating a bicycle brake

4. Power brakes - Wikipedia

   en.wikipedia.org/wiki/Power_brakes

   The pressure exerted by the driver on the pedal is multiplied by the vacuum booster, which uses engine vacuum to pull the booster's rod and diaphragm forward toward the master cylinder. The forward travel of the rod causes the piston in the master cylinder to compress; this action pushes the brake fluid through the brake lines, which lead to ...

5. Bicycle brake - Wikipedia

   en.wikipedia.org/wiki/Bicycle_brake

   The rod-actuated brake, or simply rod brake (roller lever brake in Raleigh terminology), uses a series of rods and pivots, rather than Bowden cables, to transmit force applied to a hand lever to pull friction pads upwards against the inner surface, which faces the hub, of the wheel rim. They were often called "stirrup brakes" due to their shape.

6. List of Wheeler Dealers episodes - Wikipedia

   en.wikipedia.org/wiki/List_of_Wheeler_Dealers...

   Work Completed: Replaced brake servo and master cylinder, track-rod ends (and did wheel alignment and tracking), re-cored radiator, electrics professionally checked, replaced the hazard warning light switch, resoldered the scotch locks in the wiring loom, fitted a new metal plate at the bottom of the aerial, lubricated left-side power window ...

7. Hydraulic brake - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_brake

   The spinning disc brake will be adjacent to the piston with the larger cross-section. Suppose the diameter of the master cylinder is half the diameter of the slave cylinder, so the master cylinder has a cross-section four times smaller. Now, if the piston in the master cylinder is pushed down 40 mm, the slave piston will move 10 mm.