enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...

3. Power brakes - Wikipedia

   en.wikipedia.org/wiki/Power_brakes

   The master cylinder is located behind the driver’s side dashboard mounted on the vacuum booster. The pressure inside of the master cylinder is created by a primary and secondary piston. These are pushed by the output rod of the vacuum booster to compress fluid within its primary and secondary chambers (hydraulic pressure). The hydraulic ...

4. Pull-rod suspension - Wikipedia

   en.wikipedia.org/wiki/Pull-rod_suspension

   As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.

5. Valvetrain - Wikipedia

   en.wikipedia.org/wiki/Valvetrain

   Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is fitted with a lifter , upon which the camshaft makes contact.

6. Railway brake - Wikipedia

   en.wikipedia.org/wiki/Railway_brake

   A spring system: James Newall, carriage builder to the Lancashire and Yorkshire Railway, in 1853 obtained a patent for a system whereby a rotating rod passing the length of the train was used to wind up the brake levers on each carriage against the force of conical springs carried in cylinders. The rod, mounted on the carriage roofs in rubber ...

7. Single- and double-acting cylinders - Wikipedia

   en.wikipedia.org/wiki/Single-_and_double-acting...

   Typical horizontal steam engine with double-acting cylinder. A double-acting cylinder is a cylinder in which the working fluid acts alternately on both sides of the piston. . In order to connect the piston in a double-acting cylinder to an external mechanism, such as a crank shaft, a hole must be provided in one end of the cylinder for the piston rod, and this is fitted with a gland or ...