Ads
related to: mustang 8.8 rear end width chart size dimensions
Search results
Results from the WOW.Com Content Network
The Ford 8.8 is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1983 Ford trucks. The axle was developed to replace the Ford 9-inch axle. This axle is still in production today for a variety of Ford vehicles.
The Fox platform, like most compact and mid-size cars of the late 1970s, was designed with a rear-wheel drive layout. In contrast to the full-size Fords and Mercurys of the time, the Fox platform used unibody construction. The Fox platform used MacPherson strut front suspension, continuing the use of a live rear axle suspension configuration. [12]
Factory center sections carry two (2) different bearing dimensions (3.0625 and 3.250 in or 77.7875 and 82.5500 mm). Factory axle shaft and differential spline count is 28 and 31, although aftermarket axles with 35 and 40 spline count are readily available from reputable manufacturers. Wide variety of axle bearing flanges were fabricated.
For 1981, Lincoln made the Town Car and four-door Continental Mark VI its full-size model line to reduce its model overlap, with the Continental later becoming a mid-size sedan (based on the Fox platform); the two-door version of the Mark VI was replaced in 1984 by the Mark VII coupe. For 1983, the Ford LTD and Mercury Marquis became mid-size ...
The Mustang has a trunk capacity of 13.5 cubic feet (380 L) with its seats up. [58] The Mustang has the capacity to hold four passengers and uses a rear-wheel drive layout with its engine placed at the front. [59] [60] The vehicle uses a unibody chassis, [61] and is based upon the D2C platform, [62] which it shares with the previous generation ...
The third-generation Mustang was manufactured and marketed by Ford from 1979–1993, using the company's Fox platform and colloquially called the Fox body Mustang.During its third generation, the Mustang evolved through several sub-models, trim levels, and drivetrain combinations during its production and seemed destined for replacement with a front-wheel drive Mazda platform.
Planetary differential used to drive a chart recorder c. 1961. The motors drive the Sun and annular gears, while the output is taken from the planet gear carrier. This gives 3 different speeds depending on which motors are on. Non-automotive uses of differentials include performing analogue arithmetic. Two of the differential's three shafts are ...
The size of the 2010 Mustang GT's dual exhaust tips had been increased by one-half of an inch to 3.5 in (89 mm) while the exhaust note has been improved to enhance the sound of the V8. [54] Like the base V6-equipped Mustang, the 2010 Mustang GT included new spring rates and dampers to improve ride quality and control.
Ads
related to: mustang 8.8 rear end width chart size dimensions