Search results
Results from the WOW.Com Content Network
A Bowden cable (/ ˈ b oʊ d ən / BOH-dən) [1] is a type of flexible cable used to transmit mechanical force or energy by the movement of an inner cable relative to a hollow outer cable housing. The housing is generally of composite construction, consisting of an inner lining, a longitudinally incompressible layer such as a helical winding or ...
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
As the throttle is closed, this pressure is reduced due to restricting the fuel/air mixture available to the engine, i.e. causing it to operate at lower power than it is capable of producing. Oil temperature gauge - Indicates the engine oil temperature. Oil pressure gauge - Indicates the supply pressure of the engine lubricant.
This regulates internal pressure by throttle position. A secondary function of this cable is to down-shift ("kick down") to a lower gear when the Throttle Valve is in the full stop position (throttle pedal is fully depressed) and road speed is below a set point regulated by a mechanical governor on the output shaft.
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
In some markets a W-S (Winter - Standard / Sport) switch was provided on the shifter. Activating S mode changes a linkage which effectively shortens the throttle pressure bowden cable. This causes later, higher RPM shifts and on some models a move off in 1st gear instead of 2nd. On V8 models a B (Brake) range is available on the shifter.